Adding individual names to Team Jerseys, corporate shirts and many other garments has never been easier with Stahls Pre-Spaced Cut Names. These names arrive on a clear carrier ready to apply as desired. With these individual names you can give your garments a personal touch with minimal effort. We can offer these names cut in a straight line, curved or on an arch.
We cut and offer a wide variety of different fonts and various colours which can be cut at different letter heights or sizes listed in the options below. We have listed six standard fonts to choose from but are not limited to just these fonts. We can also use almost any font from all the standard and most common Serif/ Sans-Serif fonts found on most computers. We can also cut other unique fonts if desired, but will need the digital font file which is usually a TTF (True Type Font) or OTF (Open Type Font). With unique fonts we recommend refrain in using fonts or typefaces that have distortions or eroded effects with very detailed lettering that give the text a vintage or weathered look, this will not allow for a clean precise finish to the cut. Names that are hyphenated would more than likely require 2 lines of text and will be charged as 2 names but will be supplied as one transfer for ease of application.
See Below Table for Pricing
| LETTER HEIGHT | STRAIGHT | CURVED |
| 1cm High Lettering | $2.50 per name | $3.00 per name |
| 2cm - 3cm High Lettering | $3.00 per name | $3.50 per name |
| 4cm - 5cm High Lettering | $3.50 per name | $4.00 per name |
| 6cm High Lettering | $4.00 per name | $4.50 per name |
| REFLECTIVE SILVER | Add $1.00 to the above tables | Add $1.00 to the above tables |
**MAXIMUM 300mm wide
*** These names are priced per line of text. If you require names or text over two lines this will be billed as two names or two lines of text and would be double the base price in each letter height category .
STANDARD FONTS
APPLICATION
- Set your Iron temperature between wool & cotton. Use a dry iron. DO NOT USE STEAM
- Iron garment where name is to be applied.
- Position name with mylar backing still attached.
- Iron the mylar backing with medium pressure for 20 to 30 seconds. Iron evenly do not use excessive force.
- Allow to cool and carefully remove the carrier from the name
- If the name lifts while removing the mylar backing replace the carrier & re-iron as in step 5.
